Ryobi STM405 Manual Del Operador página 5

 Slide lower back panel up between side panels until top
edge moves behind lip of upper back panel as shown in
Figure 4.
NOTE: The lip of the upper back panel should be on the
interior side of the cabinet.
 Insert M5 bolts (6) through the back holes of the panels
as shown in Figure 4. Secure with M5 nuts (6).
 Align holes in bottom panel with holes in lower back and
side panels as shown in Figure 5.
NOTE: The flat surface of the bottom panel should face
upward, toward the interior of the cabinet.
 Insert M5 bolts (6) through the side holes and back holes
of the bottom panel as shown in Figure 5. Secure with
M5 nuts (6).
 Insert M4 bolts (4) through the front facing corner holes
of the cabinet as shown in Figure 6. Secure with M4 nuts
(4).
NOTE: M5 bolts and nuts should only be used to secure
the side and back facing panels of the cabinet. M4 bolts
and nuts should only be used to secure the front facing
corners of the cabinet.
M5
M5 BOLT
M5
LOWER BACK PANEL
M5
M5
M5
M5
M5
M5 BOLT
M5
M5
BOTTOM PANEL
M5
M5
M5
M5
M5
M5 M5
M5
M5
M5
M5
M5
M5 NUT
M5
M5
M5
M5
M5
M5 NUT
ASSEMBLY
 Insert shelf clips (4) into slots in the interior of the cabinet
as shown in Figure 7. Make sure shelf clips are all on the
same level.
 Insert interior shelf into cabinet by tilting shelf diagonally
and placing onto shelf clips.
 If mounting onto a wall rail, insert bumpers (2) into round
holes on the bottom back panel of the cabinet as shown
in Figure 8.
 Install cabinet doors by inserting hinge rod through the
hinge hole as shown in Figure 9.
NOTE: For ease of installation, doors can be installed
after mounting cabinet onto LINK wall rail or wall stud.
See Installation section.
M4
M4
M4
M4
M5
M5
M5
Fig. 4
M5
M5
SLOT
M5
M5
M5
Fig. 5
5 — English
M4
M4
M4
M4
INTERIOR SHELF
SHELF CLIP
M4 BOLT
M4 NUT
Fig. 6
Fig. 7