Ryobi STM405 Manual Del Operador página 6

BUMPER
HOLE
BUMPER
WARNING:
To reduce the risk of injury, do not attempt to use this
product until you have read thoroughly and understand
completely this operator's manual and the operator's
manual for any power tools used.
TOOLS NEEDED (NOT INCLUDED)
For mounting onto LINK wall rail:
Phillips Screwdriver, #8 Screws (optional)
For mounting onto wall studs or concrete:
Drill, Hammer, Level, Pencil, Phillips Screwdriver, Concrete
Anchors (if mounting onto concrete)
MOUNTING THE CABINET ONTO LINK WALL
RAIL
See Figure 10.
WARNING:
Only install screws into sound structural supports (such
as studs and concrete) in areas where no electrical wires,
utility cables, pipes, or other obstructions are located.
Failure to follow these instructions can result in death,
electrical shock, or other serious personal injury.
ASSEMBLY
Fig. 8
INSTALLATION
WARNING:
Do not lift the product without help. Hold it close to your
body. Keep your knees bent and lift with your legs, not
your back. Ignoring these precautions can result in back
injury.
 Mount the wall rail as described in the rail's Operator's
Manual.
 Insert bumpers (2) into holes on the bottom back panel
of the cabinet if not already installed.
 For ease of installation, remove doors from cabinet before
mounting onto LINK wall rail.
 With the help of at least one other person, carefully lift the
cabinet and position the cabinet onto five of the raised
octagonal patterns on the wall rail.
NOTE: Cabinet cannot be installed over two parallel rails.
 IMPORTANT! To ensure the cabinet is seated properly,
check that the holes through the back wall of the
cabinet are lined up with the corresponding holes in
the LINK wall rail.
 If desired, insert #8 screws (not included) into these holes
in the back wall of the cabinet and into the holes in the
LINK wall rail for extra support.
 Install cabinet doors by inserting hinge rod through the
hinge hole.
To unmount the cabinet:
 Remove all of the items stored in the cabinet.
 Remove the #8 screws (if installed) from the cabinet.
 With the help of at least one other person, carefully pull
the cabinet away from the wall rail.
6 — English
HINGE ROD
HINGE HOLE
DOOR
Fig. 9