Publicidad
Idiomas disponibles
Idiomas disponibles
8
1
F
8. Install the eyepiece rack (F1) by placing the keyholes in
the rack over the mounting screws pre-installed in the
side panel, then push the rack downwards.
NOTE: If you want to remove the rack for storage or
transport, simply pull it upward.
9b
A
For the 130mm model:
9b. Loosen the knob on the dovetail holder on the side
panel. Then, insert the dovetail connected to the
optical tube with the tube rings, and retighten the knob
until the dovetail is secure in the holder.
6 I
ENGLISH
9a
For the 114mm model:
9a. Connect the optical tube assembly (A) to the
assembled base.Fully unthread the clamping knob on
the cradle and open the cradle. Place the optical tube
in the cradle as shown, close the cradle, and retighten
the clamping knob until secure.
9c
A
For the 150mm model:
9c . Connect the optical tube assembly (A) to the
assembled base.You'll need to connect the tube rings
to the tube ring mounting plate on the base. Use
the screws and lock washers already installed in the
rings to do this. It will be easiest to fi rst remove the
rings from the optical tube to assemble them onto the
mounting plate. Fully unthread the tube ring knobs and
open the rings to remove the tube.
A
Publicidad
