Taurus ALPATEC DH101 - 10L Manual De Instrucciones página 10

will stop automatically and the buzzer will beep
15 times to alert the user, that the water need to
be emptied from the drainage tank.
- Emptying the water tank: Hold the top and
bottom center of the water tank with both hands
and pull it out gently.
- Empty the collected water.
- Return water tank to its original position. The
tank full indicator will go off.
- If the tank is not positioned properly, the "tank
full" sensor will still be activated and the dehu-
midifier will not operate.
TIMER FUNCTION :
- (*) Only available in the model DH 201
- The appliance's operating time can be controlled
by Timer button (A2)
- Switch off using timer:
With the appliance running, press the timer button
(A2) as many times as may be necessary to set
the time after which you want the appliance to
switch itself off. Each press corresponds to 1h,
up to 24h.
The time selected will flash on the display screen
to indicate that this has been set and the timer
light will come on. To cancel the timer, press the
timer button (A2) until the display screen shows
0.
- Switch on using timer:
With the appliance switched off, press the timer
button (A2) as many times as may be necessary
to set the time afterwhich you want the applian-
ce to switch itself on. Each press corresponds to
1h up to 24h.
LAUNDRY FUNCTION (*):
- Press the laundry button (A3) to Laundry
function.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Stop the appliance using the on/off button.
- Unplug the appliance from the mains.
- Put the cable back in the cable housing.
- Close the cover.
- Remove the water from the water tank.
- Clean the appliance.
CARRY HANDLE/S:
- This appliance has a handle on the upper part of
the body, which facilitates comfortable transpor-
tation. (3)
SAFETY THERMAL PROTECTOR:
- The appliance has a safety device, which pro-
tects the appliance from overheating.
- If the appliance turns itself off and does not
switch itself on again, disconnect it from the
mains supply, and wait for approximately 15
minutes before reconnecting. If the machine
does not start again seek authorised technical
assistance.
CLEANING
- Disconnect the appliance from the mains and
allow it to cool before undertaking any cleaning
task.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Never submerge the appliance in water or any
other liquid or place it under running water.
- Remove the filter cover (5) and remove the filter
by pulling it, clean it with hot soapy water, rinse
it, dry it and put it back in.
ANOMALIES AND REPAIR
- Take the appliance to an authorised technical
support service if product is damaged or other
problems arise. Do not attempt to disassemble
or repair the appliance yourself as this may be
dangerous.