Descargar Imprimir esta página

Dometic RH 439LD Manual De Instrucciones página 7

Versiones de unidad libre y versiones de unidad empotrada
Ocultar thumbs Ver también para RH 439LD:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 40
B
9. Reversing the door hang
Reversing is suggested to perform in the following
way, in order to avoid breaking of the hinge bolt:
7
6
Disconnect the mains
Lay the appliance down carefully on its back
Take down the two foot-extension (1) pieces by
removing the two screws (2)
Remove the four screws (4) and take out the two
fixing feet (3)
Remove the four screws (7) the upper hing (5) and
the cover cap (6)
Remove the door (8), together with the upper hinge
(5), from the housing
11. Customer service
Before you call a service engineer, carry out the
following simple tests:
Problem
The appliance does not cool sufficiently
The appliance does not cool at all.
If after checking all the above points, the refrigerator is
still not working satisfactorily, contact your nearest
service engineer. State the problem, model, product-
and serial-number.
(Details of the model, product- and serial-number are
to be found on the data label in the top left of the
inside compartment.)
A
Figure 6.
(Fig. 7.)
5
9
8
1 1
3
4
2 2
Figure 7.
Too much food to be cooled was put in.
Door is not shut properly.
Internal air circulation is restricted.
Refrigerator not level.
Plug is not connected to the mains socket
properly
There is no voltage in the mains socket.
Insert the upper hinge (attached the miniBar)
and the covering plate in the slot on the opposite
side and secure with four screws (7).
Insert the door on the upper hinge and place it.
Mount the fixing feet (3) with hinge bolts (9)
placed into the opposite side of the feet
Mount the two foot-extension pieces (1)
Check that the door closes easily and is sealed
properly.
10. Replacing the decorative
door panel
(only free-standing model)
Removing and mounting of the door is similar to
that of described in the previous, 9 chapter. (Only
the foot on the hinge-side has to be removed!)
Remove screws (4) and pull off the frame edge (5).
Slide the decorative panel (6) out of the door frame
and insert the new panel (7), so that the upper edge
of the panel runs exactly parallel to the upper edge of
the frame. A new panel can be inserted more easily
into the upper edge of the frame when the two
corners are cut off by approx. 5 x 5 mm (8). Put the
frame edge (5) back in place and secure with screws.
Place the door on the lower hinge (9), slot the
upper hinge into the opening, press together with
the door against the housing and secure with the
two screws (11).
Possible cause
This refrigerator is equipped with overheating
protection.
An authorised service technician can check
whether this has beentriggered or not.
(Fig. 7., 8.)
Figure 8.
Solution
Put in less food to be be cooled.
Check if the door is shut.
Provide inside cool air circulation.
Level refrigerator.
Check if the connection is
proper.
Check if there is voltage.
GB
7

Publicidad

loading

Este manual también es adecuado para:

Rh 423ldaRh 449ldMb20-60