Publicidad
Idiomas disponibles
Idiomas disponibles
English
Battery
Remaining battery indicator switch
Lights ;
The battery remaining power is over 75%
Lights ;
The battery remaining power is 50% – 75%.
Lights ;
The battery remaining power is 25% – 50%.
Lights ;
The battery remaining power is less than 25%
Blinks ;
The battery remaining power is nearly empty.
Recharge the battery soonest possible.
Blinks ;
Output suspended due to high temperature.
Remove the battery from the tool and allow it to
fully cool down.
Blinks ;
Output suspended due to failure or malfunction.
The problem may be the battery so please
contact your dealer.
SPECIFICATIONS
1. Power tool
Model
Voltage
No load speed
Mixing screw diameter
(Standard accessory)
Maximum mixing screw diameter
(Body) Dimensions
Length x Height x Width
Battery available for this tool*
Weight**
*
Existing batteries (BSL3660/3620/3626, BSL18xx series, etc.) cannot be used with this tool.
** According to EPTA-Procedure 01/2014
Depending on attached battery. The heaviest weight is measured with BSL36B18 (sold separately).
Electronic control
○ Soft start
Reduces recoil against the operator by managing the
number of rotations during startup.
○ 0 Voltage Re-start Protection
The 0 voltage restart protection feature prevents the
power tool from restarting after the power has been
temporarily cut off during operation.
○ Constant speed
○ Overload protection
This protection feature cuts off the power to the motor
in the event of overloading of motor or a conspicuous
reduction in rotational speed during operation.
When the overload protection feature has been
activated, the motor may stop.
In this case, release the tool switch and eliminate causes
of overloading.
After that you can use it again.
STANDARD ACCESSORIES
In addition to the main unit (1 unit), the package contains the
accessories listed on page 247.
Standard accessories are subject to change without notice.
SELECTING ACCESSORIES
The accessories of this machine are listed on page 248.
APPLICATIONS
Mixing materials such as paint, spraying material (sand wall
coatings, tile coatings), stucco, mortar, and leveling mortar
UM36DA
36 V
0 – 500 min
–1
(in Low speed)
0 – 1200 min
(in High speed)
–1
150 mm
200 mm
929 x 224 x 109 mm
Multi volt battery
4.4 – 4.7 kg
○ Overheat protection
This protection feature cuts off the power to the motor
and stops the power tool in the event of overheating of
motor during operation.
When the overheat protection feature has been
activated, the motor may stop.
In this case, release the tool switch and cool it down in a
few minutes.
After that you can use it again.
NOTE
Due to HiKOKI's continuing program of research and
development, the specifi cations herein are subject to
change without prior notice.
10
Publicidad
