Dometic CU400BPE Instalación página 19

CONNECTING TO GAS SUPPLY
CHECK THESE SPECIFICATIONS BEFORE CONNECTING THE APPLIANCE TO THE
GAS CYLINDER /BOTTLE. THE PRESSURE REGULATORS CONNECTED BETWEEN
THE GAS CYLINDER AND APPLIANCE MUST CONFORM WITH THE CATEGORIES
GIVEN IN THE BELOW TABLE.
This appliance is designed for running off the following types of gas at the corresponding operating pressures. The gas
category (or categories) of the appliance is given on the specifications label affixed to the appliance.
CATEGORY AND COUNTRY OF DESTINATION
I3B/P(30)
AT BE DE DK FI GB NL NO PT SE SI
I3+ (28-30/37)
BE CH ES FR GB IE IT PT SI
MODEL
CU322 - CU322M
CU333 - CU333M
CU403PE - CU404PEMW - CU407PEMW
CU354MK
CU352M
CU325 - CU325M - CU404PE - CU405PEMW
CU335 - CU335M - CU402PE - CU414PE
403 - CU351MK - CU404MW - CU407MW
CU433 - CU433M - CU433ML
CU300 - CU300M
CU311 - CU311M
CU400BPE - CU400PE - CU401PE
404 - CU405MW
402 - 414
400 - 400B - 401
DURAWHEN INSTALLING AND CONNECTING THE APPLIANCE TO THE GAS
SUPPLY, ENSURE THAT THE GAS SUPPLY HOSE IS NOT TWISTED, STRETCHED OR
SUBJECTED TO ANY FORM OF STRAIN WHICH COULD CREATE A HAZARD.
The gas supply pipe connected to the appliance must be a rigid metal pipe with sealed fittings. It is possible to fit a
flexible hose, however, in this case the following conditions must be respected:
a) The hose can be accessed easily for inspection;
b) The hose must be protected against coming into contact with parts which heat up (EG: parts underneath the burners);
c) The hose must be protected against being damaged (twisting, pulling, trapping,....);
d) The hose must be protected against being trapped by moving parts (e.g. drawers);
e) The hose must not have a length over 1.5 m;
f) The hose must be replaced before its expiry date;
Once the appliance has been connected to the gas supply check for gas leaks utilising a non-corrosive fluid.
Do not use a water and soap solution. NEVER USE A FLAME TO CHECK FOR GAS LEAKS.
GAS PRESSURE
30 mbar Butane (G30)
30 mbar Propane (G31)
28-30 mbar Butano (G30)
37 mbar Propano (G31)
TOTAL RATED
THERMAL CAPACITY
kW - gr/h
4,0 - 291
4,4 - 320
4,6 - 335
5,1 - 371
5,3 - 386
5,8 - 422
6,2 - 451
6,4 - 466
6,6 - 480
6,8 - 495
7,2 - 524
7,4 - 539
7,6 - 553
8,0 - 582
9,2 - 669
REQUIRED VOLUME OF AIR
FOR COMBUSTION
m 3 /h
8,0
8,8
9,2
10,2
10,6
11,6
12,4
12,8
13,2
13,6
14,4
14,8
15,2
16,0
18,4