Publicidad
Idiomas disponibles
Idiomas disponibles
VISUAL FLAME CONTROL
Depending on the type of gas used the flame should be:
Propane (G31): blue flame without yellow tips.
Butane (G30): flame with yellow tips when ignited which becomes more intense in colour as the burner heats.
ELECTRIC HOTPLATE
BEFORE TURNING ON THE ELECTRIC HOTPLATE (OR IF THE HOTPLATE HAS
REMAINED UNUSED FOR A LONG TIME) IT IS NECESSARY TO ELIMINATE ANY
DAMP BY TURNING ON THE HOTPLATE AND LEAVING IT ON FOR 30 MINUTES
WITH THE CORRESPONDING KNOB IN POSITION 1
USE PANS WITH FLAT BOTTOMS AND WITH DIAMETERS NO LESS THAN THE
DIAMETER OF THE HOTPLATE.
DRY THE BOTTOM OF THE PAN BEFORE PLACING IT ON TOP OF THE HOTPLATE.
WHEN USING THE HOTPLATE DO NOT LEAVE THE APPLIANCE UNATTENDED AND
MAKE SURE CHILDREN ARE NOWHERE NEAR THE APPLIANCE.
The electric hotplate is controlled by a 7-position knob: position off is 0 (zero) whereas positions 1 to 6 are for
regulating the hotplate. Positions 1 to 6 correspond to an increase in temperature of the hotplate. There is a red LED
positioned next to the knob which lights up when the hotplate is on.
MICROWAVE
For the installation, use and maintenance instructions , of the microwave, consult the operating manual contained inside
the microwave.
SPIT
Ignite the oven as described in the chapter OVEN. Turn the gas knob to the required position. Insert the drip tray with
the spit already installed as illustrated in Fig. 5 - Pg. 183. Press the spit button to turn on the spit motor.
ROTATING PLATE
Position the drip tray with the rotating plate as illustrated in FIG. 6 - PG. 184. Press the purpose button to turn on
rotating plate motor.
(depending on model)
Publicidad
