American Standard Retrospect 8711000 Instrucciones De Instalación Cuidado Y Mantenimiento página 2

RETROSPECT CONSOLE ASSEMBLY PROCEDURE:
1
(1)
(3)
(2)
TOWEL BAR SCREWS
2
HS CAP HEAD SCREWS
(5)
(4)
Thread all 4 middle or center leg tubes (item #4) into
the towel bar (item #2). Turn Shelf Support (item #5) so
all 4 Shelf Support Screws are facing down when unit is
turned right-side up after assembly. Place shelf support
(item #5) over each of the 4 middle or center leg tubes
(item #4) and screw into place using supplied HS Cap
Head screws and washers.
(1)
(3)
(5)
(4) (4) (4)
(2)
Turn Towel Bar (item #2) so the Towel Bar Screws are facing down.
Screw the two front leg sub-assemblies (item #1) into the two front
holes of the towel bar (item #2). Do the same with the two rear leg
assemblies (item #3).
NOTE: Ensure the tops or caps of all 4 leg assemblies are screwed
down into the straight threaded tubing before
installing leg sub-assemblies into the towel bar (item #2).
Turn unit upside down.
3
Thread all 4 bottom leg tubes (item #6) into shelf support
(item #5) and tighten firmly.
NOTE: Threads on one end of bottom leg tube is shorter,
this is the end to thread into shelf support (item #5).
- 2 -
(6)
(5)
730757-100 Rev. 3 (6/22)