American Standard Retrospect 8711000 Instrucciones De Instalación Cuidado Y Mantenimiento página 4

2
1) Move console table legs into approximate position near the wall.
2) Place sink on console, aligning the rubber grommets on the top of the
front legs with the recesses in the underside of the front of the sink.
3) Place a level on the shelf support and use the four independently
adjustable console feet to level the assembly both side-to-side and
front-to-back.
4) Place the level on the sink and use the two independently
adjustable trumpets on the tops of the rear legs to level the sink.
5) Move the assembly into contact with the wall.
6) With a pencil, mark through the center of the two mounting holes
found on the back of the sink.
7) Move the assembly well clear of the wall.
8) Drill two pilot holes at the center marks using a 1/4" bit.
Bore in 1" deep.
9) Thread the two 5/16" headless hanger screws into the pilot holes
leaving 1-7/8" thread exposed in front of the wall.
3
Following manufacturer's instructions, install faucet and drain
assembly (not included) in sink. Be certain to apply a bead
of sealing putty on the underside of the drain to ensure a
watertight seal between the sink and the drain. Remove
excess putty immediately after tightening drain.
Move the assembly back toward the wall, guiding the sink
over the two headless hanger screws. Place washers over
studs and firmly hand-tighten nuts onto each.
4
Connect the trap to drain assembly hand tight to check alignment. It may be
necessary to cut off part of the tailpiece (area "B") or part of the horizontal leg
of the trap (area "C").
Connect hot and cold supplies lines between the fitting valve and the supply
shut-off valves. Tighten trap joints for watertight assembly. Apply a bead of
caulk around the back edge of the sink where it contacts the wall. Insert the
rectangular glass shelf onto the shelf support. Remove protective film from
glass shelf.
CONSOLE CARE INSTRUCTIONS: Rinse the product clean with clear water. Dry with a soft cotton flannel cloth.
DO NOT : Clean with soaps, acid, polish, abrasives, harsh cleaners, or a cloth with coarse surface.
For warranty information please follow this link:
https://www.americanstandard-us.com/support/warranty
In the United States:
American Standard Brands
30 Knightsbridge Rd., Suite 301
Piscataway, NJ 08854
Attention: Director of Customer Care
For residents of the United States, warranty
information may also be obtained by calling the
following toll free number: (855) 815-0004
www.americanstandard.com
Pour plus d'informations sur la garantie, veuillez suivre ce lien :
https://www.americanstandard.ca/warranty
Rear Leg
Adjustment
Lavatory
Front Leg
Grommet
of Console
Table
In Canada:
LIXIL Canada Inc.
5900 Avebury Rd.
Mississauga, Ontario
Canada L5R 3M3
Toll Free: (855) 836-9615
www.americanstandard.ca
- 4 - - 4 -
Bumper
Hanger Screw,
Washer & Nut
C
B
In Mexico:
American Standard B&K Mexico
S. de R.L. de C.V.
Via Morelos #330
Col. Santa Clara
Ecatepec 55540 Edo. Mexico
Toll Free: 800-839-1200
www.americanstandard.com.mx
730757-100 Rev. 3 (6/22)
Feet are
adjustable