Fanimation The Edgewood TF910 Serie Manual Del Propietário página 9

Assembling and Mounting the Fan Blades
1. Position the blade over the blade holder with
threaded posts showing. Make sure the bottom edge
of the blade is fully seated against the blade arm.
With a phillips screwdriver, tighten 3/16-24 x 7.5 mm
phillips head screws and flat washers to secure the
blade to the blade arm. (Figure 15)
CAUTION
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.
2. Secure the blade holders to the motor support
using the 1/4-20 x 14 mm screws throught the holes
located on the side of the motor support. (Figure 16)
Periodically check blade holder hardware and
NOTE:
resecure if necessary.
WARNING
!
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades
or cleaning the fan. Do not insert foreign objects in
between the rotating blades.
CAUTION
To reduce the risk of electric shock, disconnect the
electrical supply circuit to the fan before installing
light kit.
Blade
HARDWARE USED:
3/16-24 x 7.5mm
PHILLIPS HEAD
SCREWS
FLAT WASHER
HARDWARE USED:
1/4-20 x 14mm
SCREWS
9
Blade Holder
Arm
Figure 15
x 15
x 15
Figure 16
x 10