Using Phrase Loop To Layer Your Voice - Boss Vocal PERFORMER VE-20 Manual De Instrucciones

Using Phrase Loop to Layer Your Voice

You can use the ON/OFF pedal to control the Phrase Loop function.
What is the Phrase Loop function?
This function lets you record a monaural phrase of up to 38 seconds and play it repeatedly (i.e., play it as a loop). You can
also layer—or "overdub"—additional phrases with the first phrase. By layering different melody lines you can simulate
an a cappella chorus by yourself, or use voice percussion to add rhythm phrases to your performance.
In order to overdub using the Phrase Loop function, you'll need to set the LoopType parameter to Perform (p. 15).
1. 2.
Indicator
Lit :
Off :
Start recording
1.
Press the PHRASE LOOP button to turn the Phrase Loop function on (the PHRASE LOOP indicator
will light).
Using the ON/OFF pedal to turn the Phrase Loop function on/off
Hold down the ON/OFF pedal for two seconds or longer; the Phrase Loop function will turn on (the PHRASE LOOP
indicator will light). When you once again hold down the ON/OFF pedal for two seconds or longer, the Phrase Loop
function will turn off (the PHRASE LOOP indicator will go out).
2.
Press the ON/OFF pedal to start recording.
The REC indicator (red) lights. Now, sing the phrase that you want to record first.
3.
Press the ON/OFF pedal to stop recording.
The PLAY indicator (green) lights, and the recorded phrase starts playing as a loop.
4.
Press the ON/OFF pedal to start overdubbing.
The REC indicator (red) lights. Now, sing the phrase that you want to overdub.
5.
Press the ON/OFF pedal to stop overdubbing.
The PLAY indicator (green) lights, and the recorded phrase plays as a loop.
If you want to add additional overdubs, repeat Steps 4–5. During overdubbing, you can switch sounds as
desired.
6.
To stop phrase playback, press the ON/OFF pedal twice in rapid succession.
The PLAY indicator and REC indicator will both go out, and phrase loop playback and recording will stop.
* Press the ON/OFF pedal twice within one second.
* The recorded phrase is erased when you stop loop playback or turn off the Phrase Loop function.
3.
Recording Playback
4. 5.
Overdubbing Playback
6.
Press
twice
Stop
13