Publicidad
Idiomas disponibles
Idiomas disponibles
6. INSTALLATION GUIDELINES
•
Direct sunlight may also cause algae to grow inside
your water bottle that may later cause product
malfunction.
•
Do not locate the unit in areas where the temperature
may fall below freezing (32º F / 0º C).
•
Allow 6 inches of space between the unit and the
wall, to allow for proper air circulation to cool the
compressor.
•
Please follow the instructions to load the water bottle before plugging the unit to the
power source.
•
Make sure the hot and cold water power switches are in the OFF position before plugging
the unit to the power source.
•
Do not use an adapter plug with this unit.
•
Do not use an extension cord with this unit. If the power cord is too short, have a qualified
electrician or service technician install an outlet near the appliance.
•
Plug the unit into an exclusive properly installed grounded wall outlet. Do not cut or
remove the third (ground) prong from the power cord under any circumstances. Any
questions concerning power and/or grounding should be directed toward a certified
electrician.
ATTENTION: If you do not plan to use the water heating function for more than three days,
we recommend that you turn off the hot water power switch.
7. INSTALLING YOUR WATER COOLER FOR THE FIRST TIME
IMPORTANT STEPS BEFORE USING YOUR WATER
COOLER
BEFORE CONNECTING THE APPLIANCE TO THE POWER SOURCE,
stand upright for approximately 24 hours. This will reduce the possibility of a malfunction in
the cooling system from mishandling during delivery.
WARNING: Please make sure to turn OFF the unit when the hot and cold water tanks are
empty. Always have water inside the tanks before turning ON any switch.
The water cooler is pre-cleaned at the factory but the reservoir, hot and cold water tanks and
water lines must be flushed with fresh water before use as follows (please run the process
twice if there is an unpleasant taste or smell after the first time):
8
All manuals and user guides at all-guides.com
let it
Publicidad
