Goldanalytix CARATSCREENPEN Manual De Instrucciones página 24

Safety instructions for the electrolyte solution:
CAUTION!
irritation, as well as severe eye irritation. Read the following safety instructions
carefully. For more information, request the Safety Data Sheet of the electrolyte
solution from Goldanalytix.
 Due to transport, it is possible that some electrolyte solution my leak out of the probe
pen before the first use or that a larger amount of liquid leaks out during the
measurement. Simply clean the probe pen with a dry paper towel and dab the probe tip
carefully several times to eliminate the liquid leakage.
 Close the probe pen with the cap after each use. If the probe pen is stored open for a
longer period of time, the probe tip may dry out and the electrolyte solution may
crystallize. This impairs the functionality of the probe pen and the probe pen must be
replaced.
 If the electrolyte solution comes into contact with your eyes, rinse your eyes gently with
water for a few minutes and, if possible, remove any contact lenses. If the eye irritation
persists, seek medical advice and have the label at hand.
 Keep the electrolyte solution out of the reach of children.
Precautions regarding the lithium battery:
CAUTION!
to follow the instructions may result in fire, burns, and other hazards or injuries.
 Only use the charger supplied by Goldanalytix to charge the device.
 If possible, charge the device on non-combustible surfaces and do not leave the device
unattended while charging.
 Protect the device from heat (e.g. from continuous sunlight, proximity to hot stoves or
microwaves), as well as from water and moisture. There is a risk of explosion if the
battery overheats.
 Follow the applicable transport instructions for lithium batteries.
 Before disposing of the device, inform yourself about the applicable guidelines
regulations and follow them. More information on the disposal of the device can be
found in Chapter 8: Recycling and Disposal.
Maintenance:
Clean the measuring surface regularly with a damp paper towel. To clean the probe tip and to
remove any whitish salt crystals that may be present due to crystallization of the electrolyte
solution, get a dry paper towel and rub it gently over the tip. Do not polish the measuring
surface with the glass fibre pen!
22
The electrolyte solution contained in the probe pen causes skin
Read the precautions regarding lithium batteries carefully. Neglecting