Moser 4340 Manual De Instrucciones página 9

· If the mains cable is damaged, it should be replaced immediately at an authorised Service
Center.
· When disconnecting the hairdryer from the mains, never pull on the mains cable or on the
hairdryer itself.
· Do not hold the appliance by the mains cable to carry it and do not use the cable as a
handle.
· Do not wind the mains cable around the hairdryer.
· Keep the mains cable and appliance away from hot surfaces.
· Make sure that the mains cable is not twisted or kinked when stored.
· When using a diffuser, never set the hairdryer to a high temperature as this could result in
the overheating of the diffuser or hairdryer.
· Never insert or allow objects to fall into the openings of the appliance.
· Never use the appliance where aerosol (spray) products are being used or where oxygen is
released.
· The appliance is safety insulated and radio screened. It meets the requirements of EU
Directive 2004/108/EC regarding electromagnetic compatibility and EC Low Voltage Directive
2006/95/EC.
· The hairdryer is fitted with an overheat protection facility. Should the appliance overheat,
the heating process is interrupted and only cold air flows out. After the appliance has cooled
down, the heating element will switch on again automatically.
· As additional safety measure, it is recommended that a tested residual current appliance
(RCD) with a residual operating current of not more than 30 mA be installed in the bathroom
circuit. Your electrician will be pleased to help you.
· We are not liable for damage caused as a result of improper use or failure to observe these
user instructions.
Operation
· Connect to the mains power supply.
· The hairdryer has 3 heat settings and 2 fan settings that, thanks to separate switches, enable
a total of 6 temperature-fan settings. For short periods, the cold-shot button (C) can be used
to fix the hairstyle.
On/off switch, fan setting (E):
· Switch on the hairdryer at the on/off switch (E) and select the required fan setting.
" I " Fan setting 1, for a gentle airflow
" II " Fan setting 2, for a strong airflow
· Select the required temperature setting.
Switch for temperature settings (D):
" O "
Temperature setting 1, for cold air
" I "
Temperature setting 2, for hot air
" II "
Temperature setting 3, for hotter air
Cold Shot (C):
By pressing the button and keeping it depressed, the hairdryer can be switched to cold air for
short periods. To return to the set temperature, simply release the cold-shot button.
· Using the on/off switch (E), switch off the appliance after use.
ENGLISH
de
en
fr
it
es
pt
nl
sv
no
fi
tr
pl
cs
sk
hu
sl
ro
bg
ru
uk
el
ar
9