Publicidad
Idiomas disponibles
Idiomas disponibles
LUBRICATION
Engine Oil
NOTE: Change the engine oil when the engine
is warm. Refer to the engine owner's manual
for the correct replacement oil and filter change
recommendations.
WARNING! The engine drain plug is
located close to the muffler. To prevent burns,
the engine should be shut off and allowed to
cool slightly so the engine is still warm but the
surrounding surfaces and oil are not.
1. Park on a level surface. Apply parking brake.
2. Clean the dirt and debris from the area around
the oil fill cap.
3. Remove the cap/dipstick.
4. Locate the drain hose at the right rear of the
engine near the bypass linkage.
5. Place an adequately sized container under
the end of the drain hose.
6. Remove drain plug and drain oil into
container.
7. After oil has drained completely, replace oil
drain plug and tighten securely.
8. Fill the engine with new oil to the bottom of
the fill tube threads. Check the level with the
dipstick.
9. Replace the oil fill cap securely when the oil
level is FULL.
10. Refer to the Service Journal for oil checking
and changing intervals and change
recommendations.
Wheel and Deck Zerks
Use only good quality bearing grease.
Grease from well-known brand names
(petrochemical companies, etc.) usually maintains
a good quality.
Front Wheel Mount
Lubricate 3-4 strokes with a grease gun on each
set of wheel bearings.
Front Wheel Bearings
Lubricate 3-4 strokes with a grease gun on each
set of wheel bearings.
Deck Spindles
Lower the cutting deck completely. Lubricate with
a grease gun, 2-3 strokes per spindle.
29
Publicidad
