Samsung NX60 811 Serie Manual Del Usuario página 80

Maintenance
To perform the self-cleaning cycle
Make sure the door lock is released. Remove all racks from the oven cavity.
2
1. Make sure the oven door is closed completely and unlocked.
2. Press Self Clean once. Then, select the cleaning time by pressing Self Clean one
or more times in accordance with the table below.
Once
3-hour cycle
3. Press START/SET. The oven door is locked and the oven begins to heat up.
4. When the self-cleaning cycle is complete, the oven beeps 10 times. The door
will remain locked and the Lock icon will blink until the oven temperature falls
below 400 °F (204 °C).
5. When the Lock icon changes to an open lock, you can open the oven door. The
Lock icon changes to an open lock when the oven temperature drops below
400 °F (204 °C).
6. Press OFF/CLEAR to display the time of the day.
CAUTION
Do not use the surface burners while the gas oven is performing a self-cleaning
cycle.
WARNING
Be sure all controls are OFF and all surfaces are COOL before cleaning any part of
the range.
34 English
NX60T8115SS_AP_DG68-01323A-01_MES+EN.indb 34 NX60T8115SS_AP_DG68-01323A-01_MES+EN.indb 34
Twice Three times
5-hour cycle 2-hour cycle
3
6
To delay starting a self-cleaning cycle
1. Repeat steps 1 and 2 from the column on the left.
2. Press Delay Start. The oven door locks.
3. Set the time you want the oven to start self-cleaning using
4. Press START/SET. The oven will start self-cleaning at your specified time.
To cancel the self-cleaning cycle
You may find it necessary to stop or interrupt a self-cleaning cycle due to smoke in
the oven. To turn off the self-cleaning cycle, press OFF/CLEAR. The cycle turns off,
but the door remains locked and the Lock icon blinks until the oven temperature
falls below 400 °F (204 °C).
NOTE
Make sure all surface burners are off while
the oven is performing a self cleaning
cycle. Self-clean will not operate if a surface
burner is on.
3
2
or .
2021-02-19 오후 6:38:36 2021-02-19 오후 6:38:36
4