Publicidad
Wait one-half hour after switching off before handling
parts. This sticker is to indicate that the marked item
can be hot and should not be touched without taking
care. For device with this sticker, this device is intended
for installation in a restricted access location, access
can only be gained by service persons or by users who
have been instructed about the reasons for the
restrictions applied to the location and about any
precautions that shall be taken.
Installation
Install the equipment according to the instructions in
this manual. To prevent injury, this equipment must be
securely attached to the floor/wall in accordance with
the installation instructions. Never place the
equipment in an unstable location. The equipment may
fall, causing serious personal injury or death.
Power Supply
Device powered by Safety Extra-Low Voltage(SELV):
The power source should meet limited power source or
PS2 requirements according to IEC 60950-1 or IEC
62368-1 standard.
Device powered by AC mains supply voltage: The
equipment must be connected to an earthed mains
socket-outlet. An appropriate readily accessible
disconnect device shall be incorporated external to the
equipment. An appropriate overcurrent protective
device shall be incorporated external to the equipment,
not exceeding the specification of the building. An
all-pole mains switch shall be incorporated in the
electrical installation of the building. Ensure correct
wiring of the terminals for connection to an AC mains
supply. The equipment has been designed, when
required, modified for connection to an IT power
distribution system.
White Light Illuminator (If supported)
Possibly hazardous optical radiation emitted from this
product. DO NOT stare at operating light source. May
be harmful to the eyes. Wear appropriate eye
protection or DO NOT turn on the white light when you
assemble, install or maintain the camera.
Transportation
Keep the device in original or similar packaging while
Déclaration de conformité UE
Ce produit et - le cas échéant - les accessoires
fournis sont marqués « CE » et sont donc
conformes aux normes européennes
harmonisées applicables énumérées dans la directive CEM
transporting it.
System Security
The installer and user are responsible for password and
security configuration.
Maintenance
If the product does not work properly, please contact
your dealer or the nearest service center. We shall not
assume any responsibility for problems caused by
unauthorized repair or maintenance. A few device
components (e.g., electrolytic capacitor) require
regular replacement. The average lifespan varies, so
periodic checking is recommended. Contact your dealer
for details.
Cleaning
Please use a soft and dry cloth when clean inside and
outside surfaces of the product cover. Do not use
alkaline detergents.
Using Environment
When any laser equipment is in use, make sure that the
device lens is not exposed to the laser beam, or it may
burn out. DO NOT expose the device to high
electromagnetic radiation or dusty environments. For
indoor-only device, place it in a dry and well-ventilated
environment. DO NOT aim the lens at the sun or any
other bright light. Make sure the running
environment meets the requirement of the device. DO
NOT place the camera in extremely hot, cold, dusty or
damp locations, and do not expose it to high
electromagnetic radiation.
Emergency
If smoke, odor, or noise arises from the device,
immediately turn off the power, unplug the power
cable, and contact the service center.
Time Synchronization
Set up device time manually for the first time access if
the local time is not synchronized with that of the
network. Visit the device via Web browse/client
software and go to time settings interface.
Reflection
Make sure that no reflective surface is too close to the
device lens. The IR light from the device may reflect
back into the lens causing reflection
2014/30/UE, la directive DBT 2014/35/UE, la directive RoHS
2011/65/UE, dispositif Wi-Fi : la directive RE 2014/53/UE
5
.
Français
Publicidad
