Publicidad
Step 9: Roll in the fabric on the roller
Roll in the fabric on the roller, pay attention to the fabric direction needed, as shown
in the figure below:
Please face up the fabric when assembling.Keep the same spacing X at both ends.
Spread the fabric slowly in case of damage.
Step 10:
One end of fabric through the groove of front bar,well-distributed the fabric after pull
in all fabric, then insert shaft of roller into the square hole of gear case.As shown in
the figure below,
lf the part of front bar is a little deformed, please adjust it with tools by yourself.
9
09
EN
Publicidad
