Publicidad
Idiomas disponibles
Idiomas disponibles
convector in the event of excessive temperature convector (due to clogged vents, fan
malfunction ) . In this case, disconnect the unit from the power supply , waiting a few
minutes and remove the cause of overheating,
21. Do not touch the hot parts of the convector . Do not touch the appliance with wet hands.
22. In the case of wet convector or falling of any object through the ventilation grille of the
convector , turn it off immediately and disconnect from the network. Before re- use
with convector call for service .
23. Do not place the convector directly below the electrical outlet.
24. Always turn off the convector button before disconnecting it from the mains.
25. Do not use this heater in the immediate vicinity of a bathtub, shower or swimming pool
26. Do not use this heater if it has been dropped
27. Do not use if there are visible signs of damage to the heater
28. Use the heater on a level and stable surface or attach it to the wall, if provided for by the
manufacturer
WARNING: Do not use this heater in small rooms where there are people who are unable to
leave them by themselves, unless constant supervision is ensured.
WARNING: To reduce the risk of fire, keep textiles, curtains or other flammable materials at
least 1 m away from the heater air outlet.
Device Description: Thermo-fan
1.Handle
3. Air outlet grid
5. Power knob
A – cool air ventilation
B – warm temperature ventilation
C – hot temperature ventilation
D – control lamp
6.
Adjustable thermostat knob
OPERATION
1.
Before using the device make sure that it is on a flat and stable surface. Damage may occur if it is placed on an incline or
decline.
2.
Turn off the power knob and the adjustable thermostat, next plug into socket directly. Be sure plug fits tightly into outlet.
3.
Turn the thermostat in a clockwise direction until it reaches the maximum setting max "+".
4.
Turn the power knob to position A to have got the cool air ventilation.
5.
Turn the power knob to position B to have got the warm temperature air ventilation.
6.
Turn the power knob to position C to have got the hot temperature air ventilation.
7.
When the room reaches desired temperature, turn the thermostat knob anti-clockwise until the control lamp switch off which
indicates that the thermostat has been disconnected.
8.
Turn the power knob to position D to switch off the device.
OVERHEAT PROTECTION
This device is equipped with an overheat protection that switches off the device automatically in case of severe overheating. In this case,
unplug the device, wait for about 30 minutes for it to cool down and remove any possible cause of overheating, e.g. something covering
the heater. Check for surface damage to the appliance, the cord and the plug. If there is no damage, plug in the unit again and switch it on
as described above. If the device still does not turn on, please contact authorized service for assistance.
Maintenance
1.
Always remove the plug from the socket-outlet and allow the heater to cool down before clean it.
2.
Never immerse the device in water.
3.
Wipe the exterior surface of the heater occasionally with a soft damp cloth (not dripping wet) and dry the exterior surface
before operating the heater.
TECHNICAL DATA
Voltage: 220-240V ~50Hz
Power: 2000W
To protect your environment: please separate carton boxes and plastic bags and dispose them in corresponding waste
bins. Used appliance should be delivered to the dedicated collecting points due to hazarsous components, which may
effect the environment. Do not dispose this appliance in the common waste bin.
2.Air inlet grid
4.Feet
6
Publicidad
