Drying Rack - GE DBVH520 Manual Del Propietário

About cycle options.
DRYIN G DA MP C OOL D OW N
DELAY CLEA N LINT FIL TER
H 3 S
OLD EC
M C
Y YCLE
TO S TORE
About dryer features.
NOTE: Not all features are available on all dryer models.
lock
You can lock the controls to prevent any
selections from being made. Or you can lock
the controls after you have started a cycle.
Children cannot accidentally start the dryer
by touching pads with this option selected.
Estimated Time Remaining
Displays the approximate time remaining
until the end of the cycle.
As the cycle begins, you will see an initial
approximate total cycle time in the display.
Then lights will "race" in the display. This
means the dryer is continuously monitoring
My Cycle
(on some models)
To save a favorite cycle, set the desired
settings and hold down the My CyClE button
for 3 seconds. A beep will sound to indicate
the cycle has been saved.
To use your custom cycle, press
the My CyClE button before drying a load.
Drum lamp
Before replacing the light bulb, be sure to unplug the dryer power cord
or disconnect the dryer at the household distribution panel by removing
the fuse or switching off the circuit breaker. Reach above dryer opening
from inside the drum. Remove the bulb and replace with the same size bulb.

Drying Rack

(on some models)
A handy drying rack may be used for drying delicate items such as washable
sweaters. Place items flat on the drying rack and block such items as wool
sweaters and delicate fabrics. Dry with low heat.
To install the drying rack, pull up the lint filter slightly. Insert the drying rack
into the slots, then push the filter back down.
NOTE:
The drying rack must be used with the TIMED DRy or RACk DRy
(on some models) cycles.
Do not use this drying rack when there are other clothes in the dryer.
To lock the dryer, press and hold the lock icon
for 3 seconds. To unlock the dryer, press and
hold the lock icon for 3 seconds.
The icon of the lock next to the timer will light
up when the controls are locked.
the amount of moisture in the load.
The lights will continue until the dryer senses
a low level of moisture in the load. At that
point, the dryer will calculate and display
the approximate time remaining.
To change the saved cycle, set the desired
settings and hold down the My CyClE button
for 3 seconds.
See page 8 for more details.
11