One for All URC1211 Manual Del Usuario página 7

SETUP
4.
5.
The LED will blink twice to indicate the key has been learned
correctly.
6.
Repeat steps 3 and 4 for each key you want to learn –
remember you can learn from multiple remotes, but only one
function per key.
7.
* Some remotes send commands differently. If you find a function
cannot be learned, try holding down the key on the original remote
instead of pressing and releasing.
Hints:
• If the LED shows one long blink at step 5, the function was not
learned correctly, please try again from step 3.
• If you find one or more keys don't work properly after set up,
you can re-enter the learning mode at any time by repeating the
procedure from step 1.
• If one or more of your original remotes aren't working, you can still
set up the Essence remote by SimpleSet or Code Set Up.
Deleting a learned function
If you want to delete a learned function and return that keys to its
original state, you can use the following procedure:
1.
2.
3.
Press the key you want to reset twice – the LED should blink
twice and the learned function has been deleted.
Connect with us
facebook.com/
oneforallworldwide
Press and release* the corresponding key on the
original remote, for example Power.
When you have learned all the functions you
require, press and hold Setup key until the LED
blinks twice.
Hold down the Setup key until the LED under the
Device key blinks twice.
Press 976 – the LED should blink twice
@oneforall.worldwide linkedin.com/
company/one-for-all-worldwide/
7
youtube.com/
user/oneforallproducts