Publicidad
Idiomas disponibles
Idiomas disponibles
To ensure safe operation and service of the tester, follow these
instructions.
• Read the instructions to ensure safe operation.
• Always wear approved eye protection.
• Do not use if the charging port or housing is damaged in any way.
• Keep the rubber cover over the charging port when not in use.
• Do not expose to direct sunlight, open flame, heat sources, equipment
that produces heat, or extremes of environmental temperature. If battery's
internal temperature gets too high, the unit will shut down until the
internal temperature is lowered.
• There are no user-serviceable parts inside. DO NOT open or attempt to repair.
NOTE: Do not point the camera at the sun or any other strong energy source.
This can affect the accuracy of the camera or cause damage to the sensor.
• BURN HAZARD. Reflective materials may have a higher actual
temperature than the measured temperature. Set emissivity to
match the object being measured (see Emissivity section).
Warning or caution
Risk of Electrical Shock
Read instructions before using
Conformité Européenne: Conforms with European
Economic Area directives
UKCA: UK Conformity Assessment
This product has been independently tested by Intertek
and meets applicable published standards.
WEEE: Electronics disposal
WARNING SYMBOLS ON TESTER
OTHER SYMBOLS ON TESTER
Rotating Port Cover (bottom of unit)
WARNINGS
CAUTION
3
Publicidad
