Grundig GMS1050 Manual Del Usuario página 17

OPERATION ________________________________
Before­first­use
Remove the transparent protection sleeve on
7
the power button
appliance for the first time.
Cleaning­sensitive­and­small­objects
1
Open translucent lid
tank with water.
B
Caution­­
Do not exceed the "MAX" marking.
7
Do not operate the appliance without filling with
7
water, otherwise it will get damaged.
Use only clear, cold water.
7
2­
Put the object in the plastic cleaning basket
3­
Place the plastic cleaning basket
stainless steel tank
B
4­
Close the translucent lid
5­
Plug the power cord
outlet.
– Power on indicator light
few seconds and disappears.
6­
Press the power button
– The power on indicator light
the cleaning operation starts. It takes 5 minutes
for the appliance to finish cleaning operation.
7­
When the cleaning operation finishes, the
appliance automatically stops and the power on
indicator light C disappears.
8­
After using the appliance, disconnect the power
cord F from the power outlet.
panel before using the
D
and fill the stainless steel
A
into the
H
.
.
A
into a suitable power
F
C illuminates for a
.
D
C illuminates and
9­
Open the translucent lid
plastic cleaning basket
out the water and clean the appliance. See the
"Cleaning and care" section.
Notes
You can put multiple of jewelries at the same time.
7
Put the glasses in the plastic cleaning basket
7
always with the glasses in upward position.
Plastic cleaning basket
7
the ultrasonic energy and decreases the cleaning
power. So it might be necessary to repeat the
cleaning operation more than once.
Be sure that the water level does not exceed the
7
"MAX" marking after placing the objects into the
Stainless steel tank
.
H
exceeded, take an object out until the water level
again matches with the "MAX" marking.
The object should be immersed well into the
7
water.
Do not press power button
7
indicator light
Press it after the light disappears.
The appliance has an integrated timer for 5
7
minutes of operation.
If you want to stop the cleaning operation earlier
7
than 5 minutes, press the Power button
Cleaning­metal­bracelets­of­
waterproof­watches
1­
Open translucent lid
tank B with water.
Caution­­
Make sure that the watch is waterproof and
7
suitable for cleaning in the Ultrasonic Cleaner.
Do not exceed the "MAX" marking.
7
Do not operate the appliance without filling with
7
water, otherwise it will get damaged.
Use only clear, cold water.
7
2­
Place the watch onto the plastic watch holder
in the plastic cleaning basket
A and take out the
with the object. Pour
H
absorbs one third of
H
B . If the "MAX" marking is
D
while power on
C
illuminates for a few seconds.
A
and fill the stainless steel
.
H
ENGLISH
H
D .
G
17­