Basic Set-Up And Connections; Initial Setup - Sanyo DS27425 Manual Del Propietário

BASIC SET-UP AND CONNECTIONS

INITIAL SET-UP
1. Install batteries in remote control,
see page 9.
2. Connect signal, see below.
3. Plug in AC power cord.
CONNECTING CABLE SERVICE, OR RF ANTENNA, OR SATELLITE DISH
RECEIVER TO TV
‚
Cable Box
IN OUT
Notes:
– If you do not have a
cable box, connect
cable directly to TV
75 ohm jack or VCR.
– If you do not have a
VCR, connect signal
directly to TV 75 ohm
jack.
CATV FRANCHISE NOTE:
Cable companies, like
public utilities, are fran-
chised by local government
authorities. To receive cable
programs, even with equip-
ment which is capable of
receiving cable channels,
the consumer must sub-
scribe to the cable
company's service.
I The TV will automatically select the correct Antenna mode
for the type of RF signal you connect.
I TV will switch off automatically after 15 minutes if there is
no signal reception (cable out or station not broadcasting).
4
Need help?
Visit our Web site at
‚
Satellite Receiver
CATV IN
CH3
CH4
VIDEO L-AUDIO-R
IN FROM
OUT TO TV S-VIDEO
VIDEO L-AUDIO-R
IN
FROM ANT.
OUT
OUT TO TV
TV Back
AUDIO VIDEO INPUT
COMP AV2
VIDEO
AUDIO
OUTPUT
Y
Pb
L
S-VIDEO
(MONO)
Pr
R
www.sanyoctv.com
4. Press POWER key to turn on TV.
5. Follow on-screen instructions, see
pages 11 ~ 12.
‚
RF Antenna
SAT.
VCR Back
UHF/VHF/CATV
75Ω
Exception—When the Video mode is selected, the TV will
not automatically switch off when signal reception has
stopped for 15 minutes.
I If you move the TV to a new location, press the RESET
key twice after connecting the signal and turning on the
TV.
1-800-877-5032
or Call
Operational Tip for No Signal
Connection:
If the TV is used as a monitor only, with a
DVD player or some other type of external
equipment, and no cable or antenna signal
is available, the following setup is
necessary:
– Your TV is designed to automatically
search for available channels. Therefore,
the initial start up requires that you press
the MENU key, enabling the TV to auto-
matically go through the channel search
process before you can operate the TV.
After the initial channel search is com-
pleted, you must press the MENU key
again to complete the channel search
process. This may take several minutes.
– After the channel search process is com-
plete (2 searches), you can press the
INPUT key on the remote control to use
the TV as a monitor.