Basic Set-Up And Connections - Sanyo DS27820 Manual Del Propietário

BASIC SET-UP AND CONNECTIONS

QuickTips
The TV will automati-
I
cally select the
correct Antenna
mode for the type of
RF signal you
connect.
TV will switch off
I
automatically after 15
minutes if there is no
signal reception
(cable out or station
not broadcasting).
E E x x c c e e p p t t i i o o n n —When the
Video mode is
selected, the TV will
not automatically
switch off when
signal reception has
stopped for 15
minutes.
If you move the TV to
I
a new location, press
the RESET key twice
after connecting the
signal and turning on
the TV.
N N e e e e d d h h e e l l p p ? ?
V V i i s s i i t t o o u u r r W W e e b b s s i i t t e e a a t t
www.sanyoctv.com
o o r r C C a a l l l l 1 1 - - 8 8 0 0 0 0 - - 8 8 7 7 7 7 - - 5 5 0 0 3 3 2 2
CATV FRANCHISE NOTE:
Cable companies, like public
utilities, are franchised by
local government authorities.
To receive cable programs,
even with equipment which
is capable of receiving cable
channels, the consumer
must subscribe to the cable
company's service.
4 4
INITIAL SET-UP
1. Install batteries in remote control, see page 7.
2. Connect signal, see below.
3. Plug in AC power cord.
4. Press POWER key to turn on TV.
5. Follow on-screen instructions.
CONNECTING CABLE SERVICE, RF ANTENNA, OR SATELLITE DISH
RECEIVER TO TV
‚
C C a a b b l l e e S S e e r r v v i i c c e e
Note: If you do not have a VCR
connect signal directly to TV 75
ohm jack.
S-Video Input Terminal
To enhance video detail use the AV1
S-Video jack instead of the AV1 Video jack,
if available on your external equipment. (An
S-Video connection will override connection
to the AV1 video input jack. See page 5.)
Audio Output Jacks
Connect external audio equipment here
(see page 6).
480i Component Video In Jacks
(Component 2, Y, Pb, Pr)
Connect digital video equipment here
(see page 6).
Note:
Audio/Video Input (AV2) and
Component inputs share the same audio
(R/L) input jacks.
POSITIONING THE TV
Do not position the TV in a confined
area. Allow space for normal air
circulation around electronic parts.
‚
S S a a t t e e l l l l i i t t e e R R e e c c e e i i v v e e r r
Audio/Video Input Jacks (AV1 / AV2)
Connect video equipment here (see
pages 5 ~ 6).
Notes: S-Video connection will over-
ride an AV1 video connection.
‚
R R F F A A n n t t e e n n n n a a
V V C C R R B B a a c c k k
T T V V B B a a c c k k