Publicidad
2.6 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
FDD connector
(33-pin FLOPPY1)
(see p.2 No. 29)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Serial ATAII Connectors
(SATA2_2: see p.2, No. 18)
(SATA2_3: see p.2, No. 17)
(SATA2_4: see p.2, No. 19)
(SATA2_5: see p.2, No. 20)
Serial ATA3 Connectors
(SATA3_0: see p.2, No. 16)
(SATA3_1: see p.2, No. 15)
Serial ATA (SATA)
Data Cable
(Optional)
ASRock P67 Pro3 Motherboard
These four Serial ATAII (SATAII)
SATA2_3
SATA2_2
connectors support SATA data
cables for internal storage
devices. The current SATAII
SATA2_5
SATA2_4
interface allows up to 3.0 Gb/s
data transfer rate.
These two Serial ATA3 (SATA3)
connectors support SATA data
cables for internal storage
SATA3_1
SATA3_0
devices. The current SATA3
interface allows up to 6.0 Gb/s
data transfer rate. If you install
the HDD on the eSATA port on
the rear I/O, the internal
SATA3_1 will not function.
Either end of the SATA data
cable can be connected to the
SATA / SATAII / SATA3 hard
disk or the SATAII / SATA3
connector on this motherboard.
the red-striped side to Pin1
19
Publicidad
