Cardin Elettronica S486 Serie Datos Técnicos, Dibujos Técnicos De Instalación Y Referencias página 14

The receiver cards are fitted with two relays the outputs of which are marked CH1 (N.O. contact) and CH2
(N.O./N.C. contact). The relays CH1 and CH2 can be activated by selecting the functions A-B-C-D and made
to correspond with the transmitter channels CHA-CHB-CHC-CHD by setting the jumpers "J1" situated on
the circuit board (see fig. 7).
Mini receivers IP20 (fig. 8)
- The mini receiver (printed circuit CS1134) is housed in an indoor container and is fitted with an 8-way
terminal board with the following electrical connections:
- 12V ac/dc between binding posts 7-8 - 24V ac/dc between binding posts 6-8.
The receiver cards are fitted with two relays the outputs of which are marked CH1 (N.O. contact) and CH2
(N.O./N.C. contact). The relays CH1 and CH2 can be activated by selecting the functions A-B-C-D and made
to correspond with the transmitter channels CHA-CHB-CHC-CHD by setting the jumpers "J1" situated on
the circuit board (see fig.8).
Status led "L1" on the receiver
Flashing rapidly: cancelling a single user
Flashing slowly memorising a single user
Continuously lit: memory full
Functions
Attention! Before memorising the transmitters for the first time remember to cancel the entire
memory content.
Memorising a channel (fig. 5,6,7,8)
1. Keep button "P1" MEMO pressed down and the led "L1" will start to flash slowly
2. Press the channel on the transmitter which is to be memorised.
3. Keep button "P1" pressed down and wait until LED "L1" starts to flash again.
4. Press the channel on the transmitter which is to be memorised again (same transmitter, same channel.
14