Product Use - Greencut GTC130X Manual De Instrucciones

50

PRODUCT USE

MIXING INSTRUCTIONS
1. Put half of the gasoline you are going to use into a fuel canister.
2. Add the synthetic oil for two-stroke engines.
3. Close the canister and shake it tightly to mix the gasoline with the oil.
4. Add the rest of the gasoline and shake the drum again.
5. Put the fuel canister lid on and clean up any spilled fuel.
FILLING THE FUEL TANK
1. Place the machine on a flat surface.
2. Clean any dirt or impurities from the fuel filler flap.
3. Remove the fuel cap and fill the fuel tank with fresh and clean fuel mixture.
4. Replace the cover and tighten it securely.
5. Clean up any fuel residue before restarting the machine.
• Do not use fuel substitutes in your engine, such as ethanol or methanol, the use of such fuel will cause damage
and void any applicable warranties.
• Two-stroke engines must be used with a 25:1 fuel mixture ratio.
• It is normal for a new engine to emit smoke during the first 5 hours of use during operation.
• Mix only the fuel you will need. Do not store fuel for more than 30 days.
• Use only new unleaded 95 gasoline.
• Never use old or contaminated fuel to mix with 2-stroke oil.
• Do not overfill the fuel tank and do not allow dirt or water to enter.
START-UP AND SHUTDOWN
ENGINE START
COLD ENGINE START
1. Tighten the carburetor priming pump several times to ensure that the fuel has
reached the carburetor.
2. Turn the power switch (right handlebar) to the on position.
3. Move the choke lever to the closed (
4. Hold the motorhoe with your left hand on the handlebars and pull the starter
rope until the engine explodes or starts.
ATTENTION: The recoil starter may be damaged if abused.
• Always engage the starter before attempting to start the engine.
• Never pull the starter to its limit.
• Always rewind the starter rope slowly.
5. Place the choke lever in the open position (
6. If the machine has not started (you have only heard an explosion) pull the starter cord again until it starts.
7. Allow the engine to warm up for a few minutes before starting to operate the machine.
) position.
).
Strangler