Product Use - Greencut GTC300X Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

76
PLACE THE SIDE WHEELS
1.
Secure the wheel adapter to the power tiller axle using the pin and pin.
2.
Connect the wheel to the adapter with screws and threads.
3.
Do the same operation on the other side.
1

PRODUCT USE

BEFORE STARTING THE ENGINE
PLACING THE MILLS
The milling shaft is made with a hexagonal profile to allow quick installation of blades or other accessories.
Operate as follows (see figure 6)
a) Carefully clean the shafts of the cutters and
accessories (2) by spreading a small amount of
grease to facilitate assembly and future disassembly.
b) Bearing the following in mind:
-
The cutting part of the blade must be
towards the front of the machine.
-
When working on sandy ground or without
stones, install the 2 cutters so that the
blades are opposed, on both sides of the
machine, placed on the same axis (detail A).
-
When working on stony ground, install
the two cutters so that the blades are
opposed, on both sides of the machine, to
compensate each other (detail B).
2

Publicidad

Tabla de contenido
loading

Tabla de contenido