Publicidad
Idiomas disponibles
Idiomas disponibles
set room
set room
I: When the KEY-LOCK
light lights up, the
childproof lock has been
activated.
4
48
e - 2
Starting problems.
e - 5
Tipping-over protection.
e - 6
Poor burning.
e - 7
Room temperature
above 28°C.
e - 8
Defective booster.
e - 9
Air filter dirty; or
Fuel pump dirty.
The heater has been in operation
continuously for a period of 65 hours
and has turned itself off automatically.
-- : --
Out of fuel.
(& blinking
FUEL-light)
-- : --
Too little ventilation.
(& blinking
VENT-light)
e - 1 1
Too little ventilation.
(& blinking
VENT-light)
Always contact your Zibro dealer for any malfunctioning not listed above.
AUTOMATIC DEACTIVATION
This heater is fitted with a safety system that ensures that it switches off
automatically after 65 hours continuous operation. The following will then appear
in the display:
the
button
(see section D).
AUTOMATIC CLEANING MODE
When the heater has been burning continuously for two hours at its highest
setting, the burner will automatically start an autoclean procedure. The display
will show the autocleaning code cl:05 running back to cl:00. The procedure takes 5
minutes, during which the heater will burn at its lowest setting, while the burner
autocleans. When the burner is clean again, the heater will automatically switch
back to the highest setting again.
I
CHILDPROOF LOCK
The childproof lock can be used to prevent children accidentally changing the
heater settings. When the heater is burning and the childproof lock is on, the
heater can only be switched off. Other functions are blocked then. If the heater
has already been switched off, the childproof lock also prevents accidental
ignition of the heater. Activate the childproof lock by pressing the appropriate key
and holding it down for more than 3 seconds. The KEY-LOCK indicator light will
light up (Fig. I), indicating that the childproof lock has been activated. Switch off
the childproof lock by pressing the key
seconds once again.
J
THE CORRECT USE OF 'SAVE'
The 'SAVE' function allows you to limit the temperature. When this function is
activated, the heater will automatically switch off, when the room temperature
exceeds the set temperature by 3°C. Subsequently, when the room temperature has
dropped again to the set temperature, the heater will automatically switch on again.
Activate the 'SAVE' setting by pressing the appropriate
. If desired, you can switch the heater on again by pressing
and holding it down for more than 3
Contact your dealer.
Re-ignite the heater.
Contact your dealer.
If necessary,
re-ignite the heater.
Contact your dealer.
Clean filter
Contact your dealer.
Switch the heater back on.
Refill removable tank.
Ventilate better.
Ventilate better.
key. The SAVE indicator
Publicidad
