Hifonics ZEUS EVOLUTION ZXE1000/2 Manual De Uso página 13

FIGURES
(P. 30-33)
CONNECTIONS AND CONTROLLERS (FIG. 1)
(1) POWER / PROTECT LED
(2) HIGH PASS / BAND PASS controller
(3) Selector FULL – HP – LP/BP
(4) LOW PASS / BAND PASS controller
(5) LINE OUTPUT (L & R)
(6) LINE INPUT (L & R)
(7) Connector for the included bass level remote controller
(8) BASS BOOST controller
(9) LEVEL INPUT controller
POWER SUPPLY AND TURN ON CONNECTION (FIG. 2)
(1) GND terminal for the ground
(2) REM terminal for the turn on connection
(3) +12 V terminal for the positive-connection of the battery
(4) Vehicle's battery
(5) External cable fuse for +12V power wire (not included in the scope of delivery)
(6) Turn on wire from the head unit or the electrical antenna
(7) Fuses
2-CHANNEL OPERATION STEREO (FIG. 3)
If you run the amplifier with 2 line output channels from the head unit to operate 2 loudspeakers in stereo, con-
nect the following setup:
(1) To the head unit, line output left (L/CH1)
(2) To the head unit, line output right (R/CH2)
(3) Loudspeaker left (L)
(4) Loudspeaker right (R)
MONO OPERATION (FIG. 4)
If you run the amplifier with the 2 line output channels from the head unit to operate 1 subwoofer in mono/
bridged, connect the following setup:
(1) To the head unit, line output left (L/CH1) or subwoofer output
(2) To the head unit, line output right (R/CH2) or subwoofer output
(3) Bass level remote controller
(4) Subwoofer (L+ and R-)
NOTICE HIGH LEVEL INPUTS (FIG. 5)
Please never use the High Level Inputs and the Low Level Inputs on the RCA sockets at the same time. This
could cause a malfunction or damage the amplifier.
NOTICE POWER SUPPLY (FIG. 6)
Please note the recommendations for the cable length and the cable cross-section of the power cables in order
to ensure an adequate and safe power supply for the amplifier.
13