Installing The Motor Assembly; Bolt (17 Mm); Cotter Pin; Washer (Large) - Ryobi RMX001 Manual Del Operador

 Slide the pivot bracket onto the top of the front leg.
 Install 17 mm bolt through the hole in the pivot bracket
and tighten to prevent it from rotating.
INSTALLING THE WHEELS
See Figure 8.
 Locate the following parts:
Wheel ........................................................................... 2
Cotter Pin in plastic bag (A) .......................................... 4
Washer (Large) in plastic bag (A) .................................. 4
 Raise the front leg and position props beneath it for
support.
 Locate the two holes on the left end of the front leg.
 Install a cotter pin into the hole closest to the center of
the front leg.
 Slide a washer, a wheel, and a second washer onto the
front leg until it contacts the cotter pin.
 Install a cotter pin into the second hole.
 Using pliers, bend the ends of the cotter pins to secure
the wheel in place.
 Repeat the process on the other side to install second
wheel.

INSTALLING THE MOTOR ASSEMBLY

See Figures 9 - 10.
WARNING:
Be careful to avoid pinching your fingers or hands when
installing the motor assembly onto the pivot bracket.
 Locate the following parts:
Motor Assembly ............................................................ 1
Hitch Pin (Small) in plastic bag (B) ................................ 1
Pivot Pin ....................................................................... 1
 Pull the lock handle away from the pivot bracket and
place it in the unlocked position.
 With the help of a second person, hold the motor assembly
above the pivot bracket.
NOTE: One side of the motor assembly has two holes
and the other has one. The side with two holes should be
on the same side as the lock handle as shown in figure 9.
 Align the holes on the motor assembly with the hole and
lock handle on the pivot bracket.
 Lower the motor assembly into place.
ASSEMBLY
COTTER
PIN
PIVOT
PIN
BRACKET
11 − English
BOLT
COTTER
PIN
WHEEL
WASHER
MOTOR
ASSEMBLY
PIVOT
PIVOT
BRACKET
FRONT
LEG
Fig. 7
HOLES
WASHER
Fig. 8
LOCK
HANDLE
HITCH
PIN
Fig. 9