Operation - Ryobi RMX001 Manual Del Operador

DANGER:
Risk of explosion. Do not use this tool to mix flammable
or explosive materials. Fire or explosion can cause severe
burns or death.
WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict severe injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1 when operating this equipment.
Failure to do so could result in objects being thrown into
your eyes, resulting in possible serious injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
WARNING:
Use safety equipment. Protect your eyes, skin, and lungs
while filling, mixing, and emptying the mixer. Failure to do
so may cause serious personal injury.
WARNING:
Do not reach into the drum with your hands or insert any
other objects including trowels and shovels into it while
mixing. Contact with the tines or substances inside the
drum may lead to serious personal injury.
NOTICE:
Before each use, inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts,
caps, etc. Tighten securely all fasteners and caps and
do not operate this product until all missing or damaged
parts are replaced. Please contact customer service or
a qualified service center for assistance.
APPLICATIONS
You may use this tool for the purposes listed below:
 Mixing stucco, cement, mortar, aggregates (i.e. sand,
gravel, etc.) and other materials.

OPERATION

TURNING THE MIXER ON AND OFF
See Figure 14.
The on/off switch on the back of the motor assembly is used
to turn the mixer on and off. When the mixer is turned on,
the drum will spin. When the mixer is turned off, the drum
will stop.
OVERLOAD PROTECTION
See Figure 14.
When the mixer is overloaded or the motor is overheated
for any reason, the circuit breaker will trip and the mixer will
automatically shut off. Before resuming operation, allow the
motor to cool. After the motor is cool, press the circuit breaker
reset button and turn the motor on to continue mixing. If the
mixer still does not resume operation, unplug the tool and
empty some or all of the batch load. Do not force the mixer.
NOTICE:
Routinely make a visual inspection of the mixer and the
material being mixed. Do not let materials dry and harden
inside the drum or on any part of the product. Failure to
follow this warning could result in property damage or
malfunction of the product.
NOTICE:
Use caution when working with fast hardening material
such as quick set concrete. A few minutes of inactivity
may be sufficient to allow the material to set. Setting times
vary; refer to the material manufacturer's instructions.
14 − English
CIRCUIT BREAKER
RESET BUTTON
ON/OFF
BUTTON
Fig. 14