Publicidad
Idiomas disponibles
Idiomas disponibles
5. Initial use
Setup
Remove the unit from the packaging. Remove all packaging material before using the appliance. Before use,
check whether the infrared lamp is properly screwed in. Place the device on flat surfaces. The appliance has an
adjustable lampshade. Set the angle of the fluorescent screen in accordance with your individual requirements.
Mains connection
Connect the unit only to the mains voltage listed on the type plate.
Note:
• Ensure that there is a socket near the place where the lamp will stand.
• Lay the mains cable in such a way that no one can trip over it.
Replacing the fuse (UK plug only)
If the fuse needs replacing, please observe the following:
• Remove the mains plug.
• Lift out the fuse holder from the inside of the mains plug using a flat screwdriver.
• Pull out the fuse from the fuse holder and replace it with a new fuse type: 3A (breaking capacity 6 kA at 240 V)
in accordance with BS-1362 / SS167.
• Press the fuse holder containing the new fuse into the plug slot.
• Plug the mains plug into the socket and test to see if it works.
6. Operation
1
Switching on the lamp
To connect to the mains, fully insert the plug into the socket. Once inserted, the „5 min" LED will
flash. This is the readiness indicator (standby). Press the On/Off button (4) once to switch on the lamp.
2
Enjoying the light
The recommended duration of treatment is maximum 15 minutes and should be limited to a ma-
ximum of two treatments a day. We recommend selecting a shorter radiation period to start with.
However, the skin of some people may show an over-sensitive (e.g. with extreme redness, blistering,
itching, heavy sweating) or allergic reaction to heat radiation, even when the lamp is used correctly. If
symptoms are not relieved after 6 to 8 applications, stop using the device and consult your doctor.
3
LED display/timer
The IL 35 infrared lamp indicates your current treatment time with the aid of 3 LEDs.
The treatment time can be set at the following 3 levels.
To scroll through the timer, hold down the On/Off button (4) until the required timer level lights up.
The levels are as follows:
Treatment time
5 minutes
10 minutes
15 minutes
The lamp switches off automatically once the set treatment time has elapsed. To switch off the lamp
manually, repeatedly press the On/Off button (4) until only the „5 min" LED is flashing, the other LEDs
are off and the lamp goes out.
Number of lit LEDs
1
2
3
11
Publicidad
