Publicidad
Idiomas disponibles
Idiomas disponibles
c TEMP indicator
If an abnormally high temperature is detected within the
unit, the indicator turns on red.
Rear View
a SYSTEM TC connector
Not used by this system.
b Remote connectors (1/2, 3/4, 5)
Not used by this system.
c AC power supply units
Insert the power cords and connect to power outlets.
Two AC power supply units are installed at the factory.
Using the two power supply units provides power supply
redundancy. When used in systems that require reliability,
power supply redundancy allows the unit to continue
operating even if one of the power supply units fails.
For details about replacing a power supply unit, consult
your Sony sales or service representative.
d USB connectors (rear panel)
USB devices not described in this document are not
supported.
Notes
• Of the four USB connectors on the rear panel, only the bottom right port
supports power delivery (900 mA). The other three ports do not support
power delivery, and should be used to connect USB devices that do not
require power supplied from the USB connector.
• Use SuperSpeed USB cables.
e LAN connectors
Connect to a Gigabit Ethernet network.
f HDMI connector
Connect to a monitor using an HDMI cable.
1
1
2
LAN1
LAN2
4
5
4 6
7 8
Note
Use an HDMI cable that conforms to the following standard.
• High Speed HDMI Cable (Premium High Speed HDMI Cable)
g DisplayPort connector
Connect to a monitor using a DisplayPort cable. A
DisplayPort-to-DVI adapter cable or DisplayPort-to-
HDMI adapter cable can be used. Use an active-type
adapter cable.
Note
Use a DisplayPort cable that conforms to the following standard.
• DP v1.2a (compliant)
h Ground terminal
Connect to ground.
3
Name and Function of Parts
19
Publicidad
