Publicidad
Idiomas disponibles
Idiomas disponibles
PROBLEM
POSSIBLE CAUSE
The blade does not raise
Sawdust and dirt in the mechanism
or tilt smoothly
The blade does not run
Extension reel not of the correct rating
up to speed
or too long
The table saw is not mounted correctly.
The table saw vibrates
The stand or bench is on an uneven floor.
Damaged or bent saw blade.
The saw does not make
accurate 45° or 90° cross
Mitre gauge is out of adjustment
cuts
Faulty ON/OFF Switch
The motor fails to start.
Windings in the field armature burned or
The electrical supply is OK
damaged.
Circuit breaker too sensitive
Motor overload
The motor overheats,
Poor cooling Sawdust build up around motor.
stalls, trips circuit breaker,
blows fuses
Windings burnt out
Fuses, Circuit breakers do not have
sufficient capacity
Cutting stalls the motor
Dull blade.
Blade burns the work
The blade is "heeling"
piece
The feed rate is too fast
Blade stops when rip
The rip fence is not parallel to the blade.
cutting.
or mitre gauge groove.
Riving knife out of alignment.
NOTE. In all cases where an electrical problem occurs.
Isolate the machine from the mains supply and remove the
plug from the outlet socket before consulting a qualified
electrician. To ensure safety and reliability, with the
exception of replacing carbon brushes all repairs should be
carried out by an authorised service centre.
REMEDY
Use a brush or suitable vacuum
cleaner to remove dust and dirt.
Re lubricate.
Use the correct extension reel or
contact an electrician.
Check the mounting and secure mounting
fixings.
Secure bench or stand on a level surface
Replace the blade
Check and re-adjust the mitre gauge
Have the saw checked by an authorised
service centre.
Replace the motor by an authorised service
centre.
Possible electrical fault Have the unit
checked an authorised service centre.
Feed work piece slower into blade
Use a brush or suitable vacuum cleaner to
remove dust and dirt to increase air flow to the
motor.
Consult a qualified electrician.
Replace the blade
See section on blade adjustment.
Slow down the feed rate.
See rip fence adjustment section
See riving knife adjustment section
TECHNICAL SPECIFICATION
Voltage
Motor
No load speed
Blade size
Max Cut @ 90°
Max Cut @ 45°
Sound Pressure Level
Sound Power Level
Weight
33
GB
230-240 V ~ 50 Hz
S1 1800 W
S6 40% 2000W
5000 min
-1
250 Ø
83 mm
63 mm
L PA 110 dB(A) K=3dB
L WA 97 dB(A)
K=3dB
18.5 kg
Publicidad
