IMPORTANT SAFETY INSTRUCTIONS FOR BATTERY
●
The battery is not fully charged when you first receive it. First read the safety instructions below the follow
charging notes and procedures.
READ ALL INSTRUCTIONS CAREFULLY AND KEEP IN A SAFE PLACE FOR FUTURE REFERENCE.
1. Do not incinerate the battery even if it is severely damaged or is completely worn out. The battery can explode
in a fire.
2. A small leakage of liquid from the battery cells may occur under extreme usage or temperature conditions. This
does not indicate a failure. However, if the outer seal is broken and this leakage gets on your skin:
a. Wash quickly with soap and water.
b. Neutralize with a mild acid such as lemon juice or vinegar.
c. If battery liquid gets in your eyes, flush them with clean water for a minimum of minutes and seek immediate
medical attention.(medical notes: the liquid is 25-35% solution of potassium hydroxide.)
3. Do not connect the positive pole and the negative pole of the battery with any metal objects. Battery could be
short circuited causing damage to the battery and possibly causing severe burns or fire.
4. Charge the battery only in the chargers supplied with the product.
5. NOTE: the battery in your tool is the lithium-ion type, with no self-discharge or memory effec
CHANGE THE BLADES
●
Warning!
DO NOT operate the switch before dismantling or fitting the blades. Risk of injury!
A
The blade can be changed rapidly and expediently without any tools.
1,To change the blade, you must remove the Blade cover (A) at first. Follow the steps as shown in the upper
figure.
① Hold the machine in one hand as showed in the upper figure. Lever the retainer (B) upwards with your thumb
and forefinger of another hand.
② Hold the blade cover firmly and pull it backwards.
③ Remove the blade cover upwards.
2,Take off the blades and install another blades.
After you take off the blades you will see the gear wheels. Make sure that no dirt、grass、leaves get in the gear.
2
B
1
3
9