Rothenberger 56050 Instrucciones De Uso página 28

4.4 The thread-tapping oil
For tapping, use ROTHENBERGER high-performance thread-tapping oil art. no. 6.5010.
This oil is not suitable for tapping drinking water pipes!
Alternatively, you can use ROTHENBERGER high-performance thread-tapping fluid,
art. no. 6.5015. This fluid is suitable for tapping all pipelines including drinking water
pipelines.
Keep thread-tapping oils out of the reach of children!
Do not thin thread-tapping oil or mix it with other oils! If the thread-tapping oil becomes
mixed with water, it turns milky-white, its quality is reduced and the tapped thread displays
lower quality. It is then recommended to change the oil!
Avoid direct sunlight and store the oil in a dark place!
Close the oil container tight after use in order to prevent the ingress of dirt and water!
ATTENTION PERSONS WITH ALLERGIES!
Thread-tapping oil that lands on the skin can cause skin irritation, inflammation and
allergic reactions! When handling oil, wear protective clothing and cover exposed skin
areas. If your skin comes into contact with oil, wash it immediately with tap water and
soap. If thread-tapping oil burns onto hot workpiece or tool surfaces, this can produce
toxic vapours or gases (e.g. chlorine gas when red oil burns). If you have accidentally
inhaled this oil mist or oil vapours, go out into the fresh air immediately and consult a
doctor without delay!
4.5 Checking the thread-tapping oil
When cleaning, servicing, inspecting or repairing the machine, it is essential
to switch it off and pull out the mains plug (de-energised operation)!
 A new machine or a machine that has not been
used for an extended period is covered with an oil
film to protect it. Remove this with a clean cloth.
 Turn the rotary handle anti-clockwise in order to
move the tool carriage to the clamping chuck.
 On the right side of the machine, fill up with the
thread-tapping oil to the level of the sieve mesh.
 Ensure that the machine is still switched off and
insert the mains plug back into the socket.
 Switch on the machine and ensure that the thread-
tapping oil runs out of the thread-tapping head to the
cutting jaws. If the right amount of oil is not supplied,
regulate it with the oil adjustment screw.
24
ENGLISH
Filter
Rotary handle