Publicidad
Idiomas disponibles
Idiomas disponibles
7. Canopy Assembly.
Locate 2 screws on underside of hanging bracket and
remove screw closest to the open end of the hanging
bracket. Partially loosen the other screw. Lift canopy to
hanging bracket. Place rounded part of slotted hole in
canopy over loosened screw in hanging bracket and
push up. Twist canopy to lock. Re-insert screw that was
removed, and then tighten both screws securely. Slide
canopy cover up to canopy, aligning rounded part of
slotted holes in canopy cover with screw heads in
bottom of canopy. Turn cover to the right (clockwise)
until it stops.
8. Blade Assembly.
Time Saver: Washers for blade screws can be
set on each blade screw prior to installing
blades.
Locate 15 blade attachment screws and washers
in hardware pack. Hold blade arm up to blade
and align holes. Insert 3 blade attachment
screws (along with washers) with fingers first
and then tighten screws securely with Phillips
screwdriver. Repeat procedure for the remaining
blades.
Remove blade arm screws and lock washers
from underside of motor. If plastic motor locks
are installed with blade arm screws, discard
plastic motor locks (save blade arm screws and
lock washers to secure blade arms). Align blade
arm holes with motor screw holes and attach
blade arm with lock washers and blade arm
screws. Before securing screws permanently,
repeat procedure with remaining blade arms.
Securely tighten all screws.
Note: Tighten blade arm screws twice a year.
All manuals and user guides at all-guides.com
motor housing
plastic
motor
lock
page 7
screw
canopy cover
blade attachment
screws and washers
lock
washers
blade arm screws
hanging bracket
canopy
screw
blade
blade arm
Publicidad
