Zibro R 617 E Instrucciones De Uso página 63

1 1
3 3
5 5 a a
6 6
8 8
1 1 0 0 a a
4
60
REPLACEMENT OF THE WICK
M
ENSURE THAT THE HEATER IS OFF AND COMPLETELY
COOL BEFORE STARTING TO REPLACE THE WICK.
Open the lid and remove the removable tank.
1
2 2
Remove the batteries from the battery holder.
2
Open the front grill. Remove the combustion chamber
3
from the heater. Close the grill.
4 Pull the knurled wick adjustment knob off the heater.
4 4
5 Unscrew the three cabinet screws on the back and sides
of the heater. Pull the cabinet forward slightly, and then
remove it from the base plate.
Unscrew the four wing nuts from the wick holder.
6
5 5 b b
Lift up the wick holder and the wick mechanism.
7
Squeeze the wick to loosen the three wick pins and
8
remove the wick from the wick holder. Ensure that you
are wearing gloves and that you have a container in
which to put the old wick.
7 7
9 Put the wick holder back into position in such a way
that the holes in the wick holder are directly above the
inner sides of the recesses in the burner. Ensure that the
holes are facing down.
Fold a new wick and place it in the wick holder. Push
10
the three wick pins into the wick holder holes, and the-
9 9
refore also into the recesses inside the burner. Push the
wick with the wick holder up into the recesses as far as
possible. Push the pins firmly until you hear a clicking
sound. Ensure that the wick holder does not bend!
1 1 0 0 b b