Gallagher W-1 Guia Del Usuario página 7

Gallagher W-1 Weigh Scale User Guide
CONNECTING EQUIPMENT TO THE W-1
Connecting to Wireless Loadbars
1. On the W-1, select
Wireless
.
2. The W-1 will search for the loadbars. When the loadbars have been located,
navigate to select them from the list, then select
Note: As per the Wireless Loadbar Installation instructions, your loadbars must
be switched on and in range to display in the search list.
3. The connection process will take up to 30 seconds while pairing occurs
between the loadbars and the W-1. Once completed, select
Home
4. Press the
5. Create a new session by selecting
0.0kg. If it's not 0.0, press the
confirm the connection is working.
Note: After 15 minutes of inactivity, wireless loadbars will disconnect as W-1 goes
into sleep mode. Press
Connecting to an EID Reader
The EID Reader connects to the W-1 via Bluetooth®.
1. Turn On the EID Reader.
2. Turn On the W-1.
3. On the W-1, select
Important: You can also connect to your W-1 by initiating a Bluetooth® enabled
connection from your reader. A passcode of "0000" may be required to
complete this connection.
Refer to the EID Reader User Manual for further information on pairing the reader.
Data Device
Third party devices such as printers can be connected to receive weight
information. A data device can be connected by either Bluetooth® or Wi-Fi.
1. Turn On the Data Device.
2. Turn On the W-1.
3. On the W-1, select
Settings > Equipment Connections > Loadbars >
button.
New
Zero
button. Apply some weight to the bars to
Power
button and go to the Weigh screen to re-connect.
Settings > Equipment Connections > EID Reader
Settings > Equipment Connections > Data Device.
Connect
.
. The current weight will display as
Done
.
.
7