Porter Cable PCC520 Manual De Instrucciones página 9

Installing and Removing the Battery Pack From the Tool
WARNING:
Make certain the lock-off button is
C
engaged to prevent switch actuation before removing
or installing battery.
TO INSTALL BATTERY PACK: Insert battery pack
into tool as shown in figure C. Make sure battery
pack is fully seated and fully latched into position.
TO REMOVE BATTERY PACK: Depress the battery
D
release button as shown in figure D and pull battery
pack out of tool.
Operating Instructions
Trigger Switch & Forward/Reverse Button - Figure E
The drill is turned ON and OFF by pulling and releasing the trigger switch (1) shown in
figure E. The farther the trigger is depressed, the
E
higher the speed of the drill. A forward/reverse control
2
button (2) determines the direction of the tool and
also serves as a lock off button. To select forward
rotation, release the trigger switch and depress the
1
forward/reverse control button. To select reverse,
depress the forward/reverse control button in the
opposite direction. The center position of the control
button locks the tool in the off position. When
changing the position of the control button, be sure
the trigger is released.
LED Work Light
When drill is activated by pulling the trigger switch
(1), the integrated LED work light (8) will
automatically illuminate the work area. Do not use LED work light as flashlight.
Dual Range Gearing - Figure F
F
The dual range feature of your drill allows you to shift
gears for greater versatility. To select low speed, high
torque setting (position 1), turn tool off and permit to
stop. Slide gear shifter button (3) away from the
chuck. To select the high speed, low torque setting
(position 2), turn tool off and permit to stop. Slide gear
shifter button towards the chuck.
NOTE: Do not change gears when tool is running. If
3
you are having trouble changing gears, make sure
that the dual range gear button is either completely
pushed forward or completely pushed back.
9