Oh!FX TORNADO 2L Manual De Instrucciones página 3

INSTRUCTION MANUAL
SET UP
Prior you fix the machine, make sure that you have enough height or space around for the confetti or
streamers which will be projected, preventing that they may impact against people or objects, causing
damage.
1.Place the machine on the floor, fixed in a truss with clamps (not included) by the holes (14) and security
cable, or to the wall by the holes to anchor in the wall (15)
2.Assamble the ETUBE adaptor (9)- single or double by screwing in in the connector to the machine (10)
3– External air compressor: Connect the air tube or hose (16) from the air input (1) to the air compressor.
Turn On the air compressor and check that the pressure is between 6 - 8 Bar (90-120 PSI). Check that
there is no air leak. The machine has an air output (2) also in case you want to link various machines.
4-Plug the machine with a powercon cable (not included) into the power input (3). You can use different
control systems to fire the machine (eg: 1 CHANNEL FX PUSHER, 1 CHANNEL DMX SWITCH, etc.). Once
connected your control system, make a shooting test without loading the machine with the ETUBE. If
the setup is correct, you will hear a strong shot when firing the machine. If the air tank of the machine is
empty, you will be able to hear a "click" noise from the valve. Make sure no-one touches the connectors/
air while manipulating the machine TORNADO 2L. It also has a Power output also, in case you need to
link various units (4)
FITTING OF THE ETUBE
1- ETUBE SYSTEM: Pull the fixing pins (11) in the ETUBE adaptor (10) and turn them to its UNLOCK posi-
tion, so they remain upwards. Insert the green side of the ETUBE (12) all the way into the adaptor (10).
Pull again the fixing pins (11) in the ETUBE adaptor (10) to its LOCK and turn the ETUBE (12) until the
fixing pins lock themselves into the ETUBE (You must hear a clicking noise confirming that the ETUBE is
locked and secured).
2- The side Fixing screws (7) are to choose the inclination of the shot. Make sure they are thighten at the
chosen angle. The angle indicator (8) helps in case you have various machines and want the same angle
of shot for all of them.
3