Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
1
Installing the Motion Sensor
WARNING: Turn the power off at the circuit breaker or
fuse. Place tape over the circuit breaker switch and verify
power is off at the light fixture.
The WHITE motion sensor wire is neutral. The BLACK
motion sensor wire is hot. The RED motion sensor wire
is switched "hot".
□
Remove the existing light fixture.
□
Route the motion sensor wires through the
canopy (1) of the existing light fixture.
□
Screw the motion sensor (A) into the
canopy (1) of the existing light fixture.
1
2
Wiring the Motion Sensor
□
Connect the motion sensor wires to the light
fixture wires and the junction box wires with
wire connectors (AA):
□
□
□
□
□
Follow the instructions that came with the
existing light fixture to mount and adjust the
light fixture.
A
AA
2
5
Please contact 1-866-308-3976 for further assistance.
White to white
Black motion sensor wire to black junction
box wire
Red motion sensor wire to black bulb
holder (2) wires
Bare or green ground wire to house ground
and any light fixture ground wire or ground
screw, if present
Wires from Junction Box
Black
Ground
(L)
White
(N)
AA
Red
(Load)
2
A
HOMEDEPOT.com
Publicidad
