Publicidad
Idiomas disponibles
Idiomas disponibles
Operation (continued)
3
Adjusting the Motion Sensor
Detection Zone
□
Turn on the circuit breaker or fuse and the light
switch.
□
Perform a "walk test". Walk in an arc across
the front of the motion sensor (A).
□
Watch the light. The light will come on and the
red LED will flash indicating motion has been
detected.
□
Stop, wait for the light to turn off, and then
begin walking again.
□
Continue this process until the detection zone
has been established.
□
Adjust the sensor up, down, or side to side to
change the motion sensor (A) detection zone.
5
Adjusting the ON-TIME Switch
The "ON-TIME" switch determines the amount of time
the light will stay on full bright after all motion has
stopped.
□
Set the "ON-TIME" switch to the 1, 5, or 20
minute position.
A
MIN
RANGE
A
ON-TIME
DUAL BRITE
MAX
TEST 1 5 20
OFF 3 6 DUSK TO
MINUTES
HOUR
4
Adjusting the RANGE Dial
□
To increase the detection zone, turn the
"RANGE" dial toward the "MAX" position.
□
To decrease the detection zone, turn the
"RANGE" dial toward the "MIN" position.
NOTE: The motion sensor (A) is more sensitive to motion
moving across the front of the sensor. The motion sensor
(A) is less sensitive to motion moving directly toward the
front of the sensor.
NOTE: The higher the "RANGE" setting (sensitivity), the
greater the possibility of false triggering. To reduce false
triggering, rotate the "RANGE" control toward the "MIN"
setting.
A
6
Adjusting the DUALBRITE
Switch
The "DUALBRITE" switch determines the amount of
time the lights stay on at a reduced light level after
sundown. Switching this setting to "OFF" will not
effect the "ON-TIME" setting.
□
Set the "DUALBRITE" switch to OFF, 3 hours, 6
hours, or dusk-to-dawn (sunset to sunrise).
®
ON-TIME
MIN
MAX
TEST 1 5 20
RANGE
MINUTES
DAWN
7
Please contact 1-866-308-3976 for further assistance.
ON-TIME
MIN
MAX
TEST 1 5 20
RANGE
DUAL BRITE
®
OFF 3 6 DUSK TO
HOUR
DAWN
DUAL BRITE
®
OFF 3 6 DUSK TO
MINUTES
HOUR
DAWN
A
HOMEDEPOT.com
Publicidad
