Elinchrom Ranger Lithium Ion Battery Box Manual De Instrucciones página 11

pROTECT fAILURE MODE
• If the temperature is below -30°C
• If the temperature is over +65°C
• If the Charger voltage is over 18 V
If BATTERy BOx CANNOT BE REACTIvATED, pLEASE CHECk wHICH
fAILURE MODE IS ACTIvE:
Press and hold Battery status push button for approx.. 4 seconds. Depending
on the battery charge level 1 – 4 LED's might light up.
Release immediately the push button soon the status of the LED lights
changes; this gives information of the failure status. (Repeat this procedure in
case the push button was pressed for too long.)
If only LED 3 is flashing, the Battery Box seems to be ok. Just check
the fuse and wait until the Battery Box cooled down. The Battery Box can
overheat due to extreme hard usage or due to hot ambient temperatures.
The Battery Box is defect, if no LED lights up, or any other LED light information
appears. The "Protect Failure mode" is active. The Battery Box cannot be
recovered and should be replaced, or contact an authorised Elinchrom Service
agent.
User Manual
EN
11