Before You Start - Elinchrom Ranger Lithium Ion Battery Box Manual De Instrucciones

User Manual

BEfORE yOU START

Before starting any operation you must first fit the Battery
•
fuse. To charge the Battery Box to full capacity, follow the instructions
in chapter Battery Charging / Fuse!
EN
• The Battery Box can be used at an ambient temperature from -10°C to
+60°C, if the temperature is exceeded, the safety circuitry of the Battery
Box will cut off completely to avoid damage to the Li-Ion cells.
• The number of flashes may vary from Battery to Battery (due to aging,
recycling speed etc.).
• Even new Batteries may vary; N.B. The full capacity of the Battery is
available only after some charge cycles.
• used Batteries may need to be recycled. Check your local regulations!
Use only The orIgInal mUlTI-volTage elInChrom lIThIUm
•
BaTTery Charger!
BATTERy CHARGING / fUSE
• The Battery can be charged at an ambient temperature from 0°C to +45°C,
if the temperature is exceeded, the safety circuitry of the Battery Box will
cut off completely to avoid damages to the Li-Ion cells
• There is no Memory-Effect; the Lithium-Ion Battery can be recharged from
any charge level.
• A completely charged Battery Box will need to be recharged latest every 6
months.
1. Insert the 20 A fuse to the Battery Box.
2. Connect first the Elinchrom Li-Ion charger with the Battery Box, and then
connect the charger to the mains.
3. Charge the Battery Box until the Elinchrom Li-Ion Charger status light turns
to green.
4. Press the Battery Box push button to check, if the battery capacity is at
100% (4 green LEDs).
5. Remove first the mains connection, and then remove the charger from the
battery.
8