EMAK OS 305 E Manual De Uso Y Mantenimiento página 23

3
 SPECIFICATIONS
3.1 Product identifi cation
The tool identifi cation details are indicated on the plate (5) on the handgrip, on the tool box and in the CE compliance certifi cate in this
manual.
3.2 Product description
The electro-mechanical, battery supplied OS 305 E - SO 3005 E unit has been created to operate harvesting tools. The scheme "PRODUCT
ASSEMBLY" POSSIBILITIES (in par. 2.1.1) shows the possible combinations among power unit, extension pole and harvesting head, in order
to fi nd the best solution for the task to be carried out.
The power unit is fi tted with an energy saving and mechanical parts protecting system. The system automatically decreases the speed
after 6 seconds since the tool has got out of the branches, this way reducing its wear-and-tear . When the rakes touch the branches, it
automatically reaches at the selected speed.
The unit is supplied by the power of a 12V battery (not supplied with the machine). The battery capacity (ampere) determines the work
duration only. The power unit is composed by a hand grip body, a gearbox and an electronic control card. On the hand grip body (1) there
are an ON/OFF switch (7) which starts and stops the tool, a speed selector (8) which varies the engine rotation speed, either 1080 or 1140
rpm and a red led light (9) which shows if the tool is on or off .
On the body there is a connector (4) which joins the power unit with the battery by means of a 15 m power supply cable (14). The connection
with the battery is by means of a clamp joint (6).
On the top of the hand grip body (1) there is a clamp connection (3) for telescopic extension pole, (11) which transmits motion to the
tool.
The mechanical head is the top part of an electro-mechanical harvesting tool manufactured by EMAK s.p.a.
The electro-mechanical harvester is composed by three parts: the harvesting head, the extension pole and the power unit.
The rake vibrations are transmitted to the branches and cause the fruit falling.
The harvesting head can be assembled onto a telescopic extension pole (11), allowing to work from the ground.
WARNING!
In case of excessive eff orts a temporary stop of the tool could occur. This would be driven by the electronic card in order not to
damage the unit. After having removed the tool from the branches and having switched off and then on the electronic card by
means of the ON/OFF switch (7), the tool can be started again.
3.3 Parts supplied
• Use & maintenance manual.
3.4 Recommended use
The tool was created to be used according to the ways and limits previously described.
WARNING!
• Any other use has to be considered improper and potentially dangerous for the operators' safety. This would make any warranty
claims void.
• If it is not used for the purposes it was designed for, the tool may get damaged and cause serious injuries to personnel and
bystanders and damages to things.
17 - 72