Publicidad
Idiomas disponibles
Idiomas disponibles
2.2 - BATTERY LIFE
With medium quality alkaline AAA batteries (900mAh) with high light level, blue colour, non-active
ambient light sensor, 4 daily transmissions, the estimated duration is 12 months. With the same
operating conditions but with the light sensor active, the estimated duration is 20 months. With the same
operating conditions but with low light level, the duration is over 28 months.
Battery life depends heavily on: battery type (zinc-carbon, alkaline, lithium), use of the backlight, working
temperatures, number of daily activations.
For installations with temperatures that can drop below 0 °C, use is recommended
of AAA lithium batteries (e.g. Energizer Ultimate Lithium, Varta Ultra Lithium or similar).
After each transmission, the battery charge level is checked and if the charge level is insufficient, five
short beeps are emitted and the buttons and crown backlighting is yellow. Replace the batteries as soon
as possible.
3 - PRELIMINARY CHECKS
Once the two AAA batteries have been inserted, the keypad goes into low power mode (stand-by). To
check for correct insertion, touch any key to activate the keypad: a long beep indicates its activation.
4 - INSTALLATION & FIRST START-UP
4.1 - SAVING A CODE
Place the receiver in learning mode as indicated in the respective manual and proceed as follows,
making sure to respect the indicated time-out periods of the receiver (normally 7 seconds).
To minimise possible interferences, it is advisable to move closer to the receiver and disconnect the
antenna from it, if possible.
DESCRIPTION
Hold any key pressed to activate the keypad: a long beep
signals its successful activation.
Key in the four-digit code (factory-set) followed by the
The keypad's backlighting is deactivated and a short and
long beep are emitted.
The code is radio-transmitted and the keypad's backlighting is
reactivated in green for about one second.
If a code is keyed in which is not saved in the memory, or with an incorrect number of digits, the selector
indicates the error by lighting up the border and the keys in red, and four short beeps are emitted.
NOTE - After keying in a valid code, within 7 seconds it is possible to transmit a new command
by pressing the key
ATTENTION! Certain codes cannot be used because they are reserved to other functions. In
case of three-digit codes, do not use the number 001. In case of four-digit codes, do not use the
numbers from 0010 to 0019, and from 0020 to 0029.
4.2 – CHANGING THE MASTER CODE
Certain operating parameters of the keypad are protected by a master code which for safety reasons
should not be disclosed. Upon first installation, the default master code is 1 2 3 4. To change it, follow
the procedure below:
DESCRIPTION
Hold any key pressed to activate the keypad: a long beep
signals its successful activation.
8
or
. Two short beeps indicate that the keypad has been deactivated.
EXAMPLE COLOUR
1 2 3 4
GREEN
EXAMPLE COLOUR
BLUE
BEEP
> 1 s
+
> 1s
BEEP
> 1 s
Publicidad
